Skip to content

How the price ranges are built

Every price on this site is a typical Southern California range for installed work with a permit. Last full review: .

Three kinds of range

Published (8 ranges). The low and high come straight from published cost guides or utility pages, compared with each other. The cost page lists every source with its date.

Published, adjusted (5 ranges). We start from published ranges, then move the low or high end to fit Southern California labor, permits and utility work. The page says so, and it is an estimate, not a quote.

Desk estimate (12 ranges). Used where no good published range exists. The page says it is an estimate and shows what it covers.

What we use as sources

  • Government and regulators: the California Energy Commission, the California Public Utilities Commission and the Contractors State License Board.
  • Utilities: SCE, SDG&E, LADWP and city-run utilities, for program rules, rebates and service steps.
  • Cities: building department pages and posted fee schedules, for permit rules and fees.
  • Cost guides: Fixr, Angi, HomeGuide and NRG Clean Power, for installed price ranges. These are the weakest source type, so we compare at least two where we can and note the date.

Anything we could not confirm is left out or marked "check with the city".

How often ranges are reviewed

Each range is checked at least every 90 days, and sooner when a source or a utility program changes. The last full review was October 30, 2026. Each cost page shows the date it was checked.

What a range leaves out

Meter moves, trenching, stucco and drywall repair, extra circuits found during the work, utility fees and the equipment you choose. The range for a hard job is shown separately where it matters.

All the ranges

WorkRangeBasisSources
200 amp panel upgrade$2,500 to $4,500Published ranges, adjusted4
400 amp service upgrade$8,000 to $12,000Published ranges2
ADU electrical (subpanel and circuits)$1,500 to $8,000Desk estimatenone
Ceiling fan installation$151 to $415Published ranges2
Electrical inspection or code-violation fix$300 to $1,500Desk estimatenone
Electrical panel upgrade$2,500 to $4,500Published ranges, adjusted3
Electrician service call and repair$185 to $575Desk estimate1
Emergency or after-hours electrician$350 to $1,200Desk estimate1
EV charger plus the panel work it needs$3,600 to $7,500Published ranges, adjusted2
Generator interlock kit and inlet$400 to $1,800Published ranges, adjusted1
Hardwired smoke and CO detectors$150 to $450Desk estimatenone
Heat pump or new 240V appliance circuit$1,500 to $6,000Desk estimatenone
Home battery installation$1,500 to $4,000Desk estimatenone
Hot tub and pool wiring$800 to $2,500Desk estimatenone
Knob-and-tube replacement$8,000 to $15,000Published ranges3
Level 2 EV charger installation$1,000 to $2,000Published ranges, adjusted2
Outlets, GFCI and dedicated circuits$135 to $850Desk estimate1
Recessed (can) lighting$125 to $300 per lightPublished ranges2
Replace a Zinsco or Federal Pacific panel$2,500 to $5,500Desk estimate1
Standby generator electrical hookup$1,500 to $3,000Published ranges1
Subpanel for a garage, ADU or addition$1,200 to $2,800Desk estimatenone
Tesla Wall Connector installation$1,500 to $2,800Desk estimatenone
Transfer switch installation$400 to $2,500Published ranges1
Whole-home surge protector$200 to $800Published ranges1
Whole-house rewire$8,000 to $20,000Published ranges3

What is never shown

Aurion Electric does not publish customer reviews, job counts or "starting at" prices that were not sourced.

Who maintains this

The ranges and facts are compiled and maintained by Roviq LLC, which operates this site. No licensed electrician has reviewed these ranges yet. A named reviewer will be listed here once there is one. See About for who does the electrical work.

About the images

Images are AI-generated illustrations, not photos of completed work.

Call (909) 552-7102Quote